WHAT IS interface range command?

WHAT IS interface range command?

The interface range command allows you to configure multiple interfaces at once. The interface range command is particularly useful because switches have many interfaces and the same settings are often applied to multiple interfaces.

What does gi1 0 1 mean?

Gigabit Interface 1/0/1 indicates. 1st module of the switch and its port number 0/1.

What does gig0 0 mean?

G0/0/0-3 are the 4 built in ports for Gigabit RJ45 or SFP based ethernet. G0 is the built in RJ45 management port. Then a port channel and tunnel interface are included as example.

What does Fa0 0 mean?

Fa0/0 is the FastEthernet interface on slot 0, port 0. Fa0/1 is the FastEthernet interface on slot 0, port 1.

What is the range of values shown for the vty lines?

To configure vty lines and set a password: Open or configure vty lines. You can specify a single line or a range of lines. The range is 0–29.

What does load interval 30 mean?

If the load interval is set to 30 seconds, new data is used for load calculations over a 30-second period. This data is used to compute load statistics, including the input rate in bits and packets per second, the output rate in bits and packets per second, the load, and reliability.

What does Txload and Rxload mean?

txload = output rate / configured bandwidth * 255. rxload = input rate / configured bandwidth * 255. In other words, txload and rxload express the fraction of used bandwidth (as configured by the bandwidth command on the interface) by the traffic flowing in either direction, on a scale of 1-255.

What is the range of normal VLANs?

VLAN Ranges

VLANs Range Usage
1 Normal Cisco default. You can use this VLAN but you cannot delete it.
2-1001 Normal For Ethernet VLANs; you can create, use, and delete these VLANs.
1002-1005 Normal Cisco defaults for FDDI and Token Ring. You cannot delete VLANs 1002-1005.
1006-4094 Extended For Ethernet VLANs only.

Can a port be on multiple VLANs?

In addition to the default VLAN, the configuration can include one or more other port-based VLANs and one or more protocol VLANs. The switches covered in this guide allow up to 2048 (vids up to 4094) VLANs of all types. UsingVLAN tagging, ports can belong to multiple VLANs of all types.

How are Cisco switch ports numbered?

All physical ports on switch model M4300-96X are based on slots. Because this model supports 12 slots and each port card provides eight ports, the port numbering is in the format unit number/slot number/port number.

What does the command ip route 0.0 0.0 0.0 0.0 do?

IP route 0.0. 0.0 0.0. 0.0 Fa0/0 in plain English means “packets from any IP address with any subnet mask get sent to Fa0/0”. Without any other more specific routes defined, this router will send all traffic to Fa0/0.

Related Posts