How do you pump up a Reverb seatpost?

How do you pump up a Reverb seatpost?

Here’s how to breathe a new lease of life into it.

  1. Remove saddle. Fully extend the post and remove your saddle by undoing both of the saddle-clamp bolts.
  2. Remove valve cap. Clean all of the parts of the clamp, including the bolts and the top of the post.
  3. Inflate to 250psi.
  4. Reassemble.

How do you adjust a RockShox dropper post?

You’ll want to ADD tension. To do so, turn the barrel adjuster counterclockwise. Check the dropper post by pressing the lever. If the dropper post moves slowly, then you can add a little more cable tension by turning the barrel adjuster a couple more turns counterclockwise.

How do I change my reverb speed?

The Reverb’s return speed is still adjustable, although that’s now accomplished by lifting a rubber dust cap on the remote and using a T25 Torx wrench rather than turning a dial. The bleed port and speed adjust are located under a rubber cap.

How do you bleed a RockShox Reverb dropper post?

How to bleed a RockShox Reverb dropper seatpost

  1. Adjust the angle of the bike so that the actuator is higher than the top of the post.
  2. Fill one of the syringes three quarters full.
  3. Cycle the fluid between the two syringes until no air is flowing in as you pull the plunger out.
  4. Clean up using degreaser and paper cloth.

How does a Reverb seatpost work?

Reverb internals use a floating piston to separate the air-spring chamber at the top of the post from the oil column below it. The oil column is metered to change the height of the post, and also must support the rider, who is often banging on the post with his or her full weight.

Can you adjust travel on RockShox reverb?

We asked SRAM and the short answer is this: “No.” It turns out that each Reverb post is designed specifically around a travel.

How does RockShox reverb work?

How much pressure should I put in my dropper post?

All dropper posts use a spring to extend the seat upwards. In some posts, this air spring is small and held at relatively high pressure (around 200 – 250 psi). When the post is in the dropped position, that air pressure can be up to 3 times higher.

How much travel does rockshox reverb have?

Reverb AXS is available in 30.9mm, 31.6mm, and 34.9mm diameters, in 100mm, 125mm, 150mm, and 170mm travel lengths. Battery must be charged every 40-60 ride hours, with battery going from dead to fully charged in under an hour.

How does a RockShox dropper post work?

A dropper seatpost works with hydraulic or mechanical power. The bike rider uses a lever (usually located on the handlebar or seatpost) to easily lower the seatpost as they are riding. The lever moves hydraulic fluid or a mechanical cable through the hose to raise or lower the seatpost.

Related Posts