Why is my Zoeller pump alarm going off?
This usually means your pump is not working because a) it is not receiving any or enough power or b) your pump is old, has worn out, and needs to be replaced. Your pump alarm goes off when it senses water which can also be, more rarely, that you have some sort of plumbing leak which has triggered the alarm from above.
What does it mean when your sump pump alarm goes off?
Sump pump alarms typically start to go off when there’s too much water in the area. If the sump pump alarm is functioning properly, but it’s going off too regularly, that means there is too much water pooling in your basement.
What is a Zoeller pump alarm?
Zoeller Pump’s liquid level alarm system is useful in pump chambers, dose tanks, sump pump basins, holding tanks, lift stations, and other non-potable water applications. The alarm box is equipped with an audible and visual indicator to warn the user of a high water condition.
Can you put an alarm on a sump pump?
Installing a sump alarm on battery backup allows you to monitor the performance of your sump pump easily, even in the event of a power outage.
How do you reset a Zoeller sump pump?
How to Reset a Sump Pump
- Locate the reset button on the motor. If there isn’t one, locate the on/off switch and turn it off, or unplug the pump directly from the electrical outlet.
- Look inside of the sump pump.
- Plug the pump back in or move the switch back to the on position if there was no reset button.
Why is the alarm on my septic system going off?
The alarm works in coordination with the septic system for the purpose of warning you when the water level within the pump tank has risen too high or has dropped too low. All septic systems with pumps will normally have some sort of timer installed.
Is a sump pump alarm necessary?
Unless you have the time to check on your sump pump several times a day to make sure it’s working properly, this is where a smart sump pump alarm and sensor could help you out and save you cash and headaches in the event of a failure.
How do I fix my sump pump alarm?
Responding to a Sump Pump Alarm
- Check the power. If the power has shut off and you can turn it back on, go to the circuit breaker board and flip the switch to the pump a few times.
- If the system is powered up, check the basin’s water level.
- Inspect the sump pump alarm system.
How do I stop my sump pump from beeping?
If you just had a power outage and your backup sump pump was running, the alarm may go off temporarily until power is restored and it can recharge. If this is the case, some battery backup systems have a button to reset the alarm for 24 hours.
Why is my sump pump battery beeping?
Sometimes a beep from the pump may mean the batteries are low in the alarm. Most sump pumps have good built in alarms and alerts so if you hear beeping investigate right away when the alarm goes off.
Do sump pumps have a reset button?
If your sump pump does not have a reset button, unplugging it from its power source like we did in Step 1 will suffice to cycle the system’s motor. If your sump pump does have a reset button, now is the time to use it. Many sump pump problems can simply be solved by resetting the pump.
Why is my water alarm going off?
Potential Causes for the Alarm to Go Off This is the result of too much water usage, which could be due to several loads of laundry, an abnormal amount of dishwashing, or maybe a lot of long showers.