How does a hydraulic pressure reducing valve work?

A pressure-reducing valve is normally an open, 2-way valve that allows system pressure fluid to flow through it until a set pressure is reached downstream. It then shifts to throttle flow into the branch. The forces exerted by pressure downstream actuates a pressure-reducing valve.

What does a pressure reducing valve do?

Also called water pressure regulators, water pressure reducing valves are compact, inexpensive valves that perform two functions: They automatically reduce the high incoming water pressure from the city mains to provide a lower, more functional pressure for distribution in the home.

How do you adjust a hydraulic pressure reducing valve?

Adjust the relief valve by turning the adjuster clockwise until the reading on the gauge builds to the pressure called for on the machine drawings. This is what is known as the valve “cracking” pressure, which is the pressure at which the relief valve starts to open.

What is a hydraulic reducing valve?

In a hydraulic system, pressure reducing valves are used to lower the system pressure for use in circuits that require less pressure than the maximum system pressure. This extends the life of the lower pressure circuits and conserves energy.

Is a pressure reducing valve necessary?

Yes. In areas with high water pressure such as Draper – because our water comes down from the mountains – a PRV helps protect pipes, fixtures, and water-using appliances from damage or breaks. PRVs can save you money by reducing the amount of wasted water in your home.

Which type of valve is commonly used for lower power hydraulic equipment?

Needle-type flow control valves are generally used only on low-power systems or for flow rate-control applications.

Where is pressure reducing valve located?

Where is it located? A water pressure regulator, if you have one, is usually located where the main water line comes into the house and after the main shut off valve. This way if you need to work on or change the water pressure regulator you can simply shut off the water main to do so.

How do you size a pressure reducing valve?

The correct parameter to base the valve size selection is by velocity. Size the pressure reducing valve based on a velocity of 1-2 m/s. This range is advisable for good pressure control within the valve’s optimum flow rate range.

How do you reduce hydraulic flow?

The bigger the hole, the more flow will pass through it. Many flow controls have a variable orifice size, so turning the adjustment counterclockwise will increase flow, while turning it clockwise will close the valve, limiting the flow and slowing down the actuator.

What does pressure reducing valve look like?

A pressure reducing valve usually resembles a bell or dome. As mentioned earlier, you’ll usually see it alongside a gauge. It may be built right into your water meter. In most cases, however, you’ll find the valve in the form of a separate device that lies after the meter within your home’s water supply chain.