How to enable IP accounting?

To Enable IP accounting based on the IP packets output on the interface, use the ip accounting output-packets command in interface configuration mode. The MAC address accounting feature provides accounting information for IP traffic based on the source and destination MAC addresses on LAN interfaces.

How do I set an IP address on a Juniper router?

To configure a management port by CLI commands.

1. Use the command “family inet address” to configure a management IP address on the interface.
2. Configure a static route with the next hop to the management network default gateway set routing-options static route 0.0.0.0/0 next-hop 10.93.15.1/21.

What is traffic accounting in mikrotik?

Local IP Traffic Accounting As each packet passes through the router, the packet source and destination addresses are matched against an IP pair list in the accounting table and the traffic for that pair is increased. The traffic of PPP, PPTP, PPPoE, ISDN and HotSpot clients can be accounted on per-user basis too.

How do I enable interface on Juniper router?

Enable/Disable Interface in Juniper

1. root@Juniper# set interfaces ge-0/0/1.0 disable << This is cisco equivalent of “shutdown”
2. root@Juniper# delete interfaces ge-0/0/1.0 disable << This is cisco equivalent of “no shutdown”
3. root@Juniper#show ge-0/0/1.0. root@Juniper# run show interfaces ge-0/0/1.0 terse.

How do I find my IP route in Juniper?

show ip route

1. Syntax. show ip route [ vrf vrfName ] [ destination [ ipMask ] [ detail ] ] [ all ] [ protocol ] [ filter ] To display summary information:
2. Release Information. Command introduced before JunosE Release 7.1.
3. Description. Displays current state of the routing table.
4. Options.
5. Mode. Privileged Exec, User Exec.

How do I configure ip flow monitor?

1. Step 1: Configure the Records. NetFlow uses key and nonkey values called a record.
2. Step 2: Configure the Flow Exporter. The flow exporter exports the NetFlow data to a NetFlow collector.
3. Step 3: Configure the Flow Monitor.
4. Step 4: Create a Sampler.
5. Step 5: Apply NetFlow to Interfaces.
6. Step 6: Verification.

What is IP accounting in mikrotik?

Local IP Traffic Accounting Both the number of packets and the number of bytes are accounted. If no matching IP or user pair exists, a new entry will be added to the table. Only the packets that enter and leave the router are accounted. Packets that are dropped in the router are not counted.

How do you enable mode in Juniper?

To switch between operational mode and configuration mode:

1. When you log in to the device and type the cli command and press Enter, you are automatically in operational mode:
2. To enter configuration mode, type the configure command or the edit command in CLI operational mode.

How do you show interface on Juniper?

Use the show interfaces command to view the interface speeds. (Optional) Display the specified level of output. (Optional) Display interface description strings. (Optional) Display media-specific information about network interfaces.