Should I sand the back of my guitar neck?

Sanding down the rear of your neck will eventually wear it through when you have to repeat the process, whereas adding a new layer is a safer option, but it is also a little trickier. The lacquer on guitars is often tough but some, like nitrocellulose, are delicate and may well require you to adjust your technique.

How do you Degloss a guitar neck?

You can do this a few different ways, but the easiest method is tru oil. Another option is mixing shellac and rubbing alcohol. Just pour half and half of each together, mix them up and apply it to the neck. A few days later, go over the neck again with 0000 steel wool a little, and you should be good to go!

Can you sand down a guitar neck?

To get started, cup your hand around the neck with the sandpaper so you have contact with the entire surface area. The first few strokes will cut into the finish and you can see if you need to apply or release pressure in any spots. Also, make sure you run the sandpaper the full length of the neck.

Can I sand polyurethane off?

Yes, you can sand off polyurethane. Although using sandpaper solely will not work to remove polyurethane, you can use it at the end to remove any residual polyurethane from the wood. You can use 120-grit sandpaper or 150-grit sandpaper to remove it from the wood.

Can you sand polyurethane?

Can you sand polyurethane? Yes, you can sand in between coats of polyurethane but not the final coat. Allow at least 24 hours for the first coat to dry and cure before sanding. With a fine-grit sandpaper, gently sand along the direction of the wood grain.

How do I make my guitar less shiny?

The bacon fat is perfect. Cook some bacon, but don’t cook it all the way, only untill its half cooked. Use the its fat and gently rub into the guitars body. It removes a bit of the poly coating on the guitars body to make it darker and less shiny.

How do you make polyurethane finish less shiny?

Rub Down the Finish With Wax or Furniture Polish You can use matte polish for wood, floor wax or even a product designed for automotive use to flatten a polyurethane finish. If you want a higher-quality finish, scuff first with 400-grit or finer sandpaper, but it isn’t necessary.

Can I leave guitar body unfinished?

Without the gloss or the satin finish, your guitar will not have a fresh look. An unfinished guitar may sound better but it can only serve you for a year or so. It gets easily dirty and damaged and hence left with no visual appeal.

Can you sand sealer off?

Sealers can be removed with mechanical means such as sandblasting or grinding. But for many contractors, it’s a last resort. It destroys the original surface, exposes the aggregate and is a mess to clean up.