What are the major components of a boiler system?
What are the Main Components of a Commercial Boiler
- Burner. The burner is the part of the boiler where air mixes with the fuel source and combusts.
- Combustion Chamber.
- Heat Exchanger.
- Controls.
- Supply Lines and Return Lines.
- Circulator Pump.
- Exhaust Stack.
- Conclusion.
How many components are in a boiler?
three
The three main components of all boilers are the burner, combustion chamber and heat exchanger.
What are boiler sections?
a boiler composed of a number of sections, which are usually of small capacity and similar to, and connected with, each other. By multiplication of the sections a boiler of any desired capacity can be built up.
What are the systems required for boiler operation?
The key boiler components involved in this process are the burner, combustion chamber, heat exchanger, and controls. The burner mixes the fuel and oxygen together and, with the assistance of an ignition device, provides a platform for combustion.
What is boiler supply line?
Supply lines – supply lines are the pipes that deliver the heated water or steam to the distribution points.
What are headers in a boiler?
A header transfers a heat transfer medium (water, steam, oil, etc.), typically via pipe(s), between (one or more) boilers and (one or more) points where the heat is required. A header can connect a single boiler to a single point where heat is needed.
What are the two main types of boiler?
There are two basic types of boilers: firetube and watertube. The fundamental difference between these boiler types is which side of the boiler tubes contain the combustion gases or the boiler water/steam.
Which pipe is used in boiler?
Boiler steel pipes includes medium pressure boiler pipe and high pressure boiler pipe, it is often manufactured in seamless procedures, welded steel pipe is not applicable.
What is a manifold on a boiler?
The Manifold connects the heat source – a boiler, heat-pump or other – with the water underfloor heating circuits, regulates the incoming water temperature via the Mixing Unit and distributes this warm water throughout the floor circuits for an energy-efficient heating system.
What is a shunt pump?
A high temperature difference can cause tensions in the material and thus reduce the life of the boiler. The boiler shunt pump circulates the water from the flow pipe into the return pipe or directly into the boiler.
What are the auxiliaries and accessories of boiler?
The various boiler mountings and accessories that are used in steam boilers are water level indicator, pressure gauge, safety valves, stop valve; blow off Valve, feed check valve, fusible plug, air pre-heater, super heater, economiser and feed pump.
What are boiler auxiliaries?
Auxiliary boiler means any fuel-fired combustion equipment designed primarily to produce steam for uses other than propulsion, including, but not limited to, heating of residual fuel and liquid cargo, heating of water for crew and passengers, powering steam turbine discharge pumps, freshwater generation, and space …
Which material is used in economizer?
Carbon steel material
Carbon steel material is used for economizer tubes.
What are headers in boiler?
What is PEX manifold?
A PEX manifold includes separate manifold chambers to serve hot and cold water lines. The cold-water manifold is fed from the main water supply line, and the hot-water manifold is fed from the water heater. Water pressure in manifolds is maintained by the incoming service line.
